Tested, certified and approved — the assurance behind every article we distribute.
We are committed to sourcing and distributing products that meet recognised international and local safety requirements, while continuously expanding our range to meet the evolving needs of our customers.
Our range of safety work gloves includes products with CE certification, tested and certified through CTC, supporting compliance with applicable European personal protective equipment requirements. Selected products also carry DOSH-SIRIM approval, providing an additional level of assurance for customers requiring approved safety gloves for the Malaysian market.
Job Master safety work gloves are tested and certified through CTC, a notified body for personal protective equipment. Certification supports compliance with the European PPE Regulation and covers the mechanical and thermal performance standards below.
For customers who require approved safety gloves in Malaysia, selected articles carry approval from the Department of Occupational Safety and Health, certified through SIRIM. These are marked in the catalogue with the DOSH-SIRIM stamp.
Every certified glove carries pictograms with a performance code. Here is what each one means, and where Safeline articles sit.
Cycles of abrasion before the coating breaks through, on a scale of 1–4. Level 4 is the most durable.
Rotating-blade test, 1–5. Marked X when the blade dulls against high-performance yarn — read position 5 instead.
Force needed to tear the glove once a cut has started, 1–4.
Force needed for a stylus to puncture the palm, 1–4.
Straight-blade cut test in newtons: A = 2 N up to F = 30 N. Safeline 22-313F, 22-313F-15, S32-18B and AP-302 all rate F, the highest level.
Six characters, one for each thermal hazard, always in this order. Each is a level 1–4 — higher is better — or X, meaning that hazard was not tested.
Reads as: tested for contact heat only, achieving level 1 on the EN 407 scale. The five Xs were not tested.
22-313F rates contact heat level 1 · 33-906C rates level 2
Our safety work gloves are produced in facilities audited to recognised international management and social standards, and conform to EN 388:2016 + A1:2018.
Quality management system.
Environmental management system.
Social auditing system covering working conditions in the supply chain.
Packed as printed.Documentedon request.
Choose the type of enquiry and we'll route it to the right person. For urgent orders, please call us directly.